Milwaukee 4096 Manual del operador

TO REDUCE THE RISK OF INJURY, USER MUST READ AND UNDERSTAND OPERATOR'S MANUAL.AFIN DE RÉDUIRE LE RISQUE DE BLESSURES, L'UTILISATEUR DOIT LIR

10time. The spindle must be smooth without grooves or pitting. If the spindle is not in good condition, it is possible for the threaded spindle sleeve

11Diamond CoringFactors that infl uence diamond core performance:• Amount of coolant• Dymorig rigidity• Dymorig condition• RPM of drill motor• Feed pre

12Sharpening Procedure for Core BitsTo work effi ciently, diamond core bits must main-tain good diamond exposure. Many factors work together to provide

13WARNING To reduce the risk of injury, electric shock and damage to the tool, never immerse your tool in liquid or allow a liquid to fl ow inside the

14TECHTRONIC INDUSTRIES' warranty is for 5 year since the original purchase date.This warranty card covers any defect in material and workmanship

2PERSONAL SAFETYGENERAL POWER TOOL SAFETY WARNINGSWORK AREA SAFETYELECTRICAL SAFETY• Keep work area clean and well lit. Cluttered or dark areas invite

3SPECIFIC SAFETY RULES•Diamond coring equipment requires the use of water. When drilling overhead, use a liquid collection system. Water in contact wi

4Fig. CFig. DFig. BGROUNDINGWARNING Improperly connecting the grounding wire can result in the risk of elec-tric shock. Check with a qualifi ed electri

5ASSEMBLYWARNING To reduce the risk of injury, always unplug tool before changing or re-moving accessories. Only use accessories specifi cally recommen

61. Tighten the cradle lock.2. Loosen the socket head screw and remove the meter box.3. Remove four (4) socket head screws holding the spoked handle

7move, tighten the six (6) gib screws that secure the cradle to the column as follows.For Cat. No. 4125 & 4130 only. 1. To install a bit, grease t

8OPERATIONSecuring the Equipment to the Work Surface - Using an Expansion-Type AnchorFor Catalog No. 4125 & 4130 only. Use a 5/8" expansion-t

9Assembling and Using a Vacuum SystemFor Cat. No. 4120 only. 7. Tighten the four (4) leveling screws only enough to eliminate rocking. Over-tightening